Fayette door Found at the BEA sensor is out of adjustment may have been knocked on accident. I readjusted it tested and it\'s working fine.

You know, said that the fire door going into the leasing office lobby by the main entrance entrance chain would come out a little release device, but would not close when I tested it. It worked every single time, even though it worked every time I adjusted attention to have down to one attention, but yet it\'s still regulated underneath the operator they just performed the test and Doors all dropped out After drop testing and verifying all doors dropped out I reset all the garbage room doors all are working fine.

Assessment of rytec door on fayette st Customer states that the outside RFI reader is intermittent responding Observed door and cars entering and leaving with no issues with door.

Gate service: Arrived on site, located gate and made contact Couldn\\\'t start making noise until 7:30, did layout of angle clips and where hinges need to go. Once able to make noise removed gate cut old hinges off prepped frame and gate set new hinges on gate, set gate in opening, made sure we had good reveal and gate design was in line with fence design. Put closure back on and adjusted closure so gate wouldn\\\'t slam.

Incident number for rytec 00440333 Greg Tail shaft and spring installed in 2019 probably not covered by warranty Took off cover to drive belt sprocket and as soon as I took off the cover the bolt and washer holding sprocket onto the drive tail shaft fell and noticed the only thing holding the sprocket onto the shaft was the cover itself Also took off side covers and discovered a whole missing spring and was unavailable to locate with contact being informed Due to the sprocket having a potential hazard of sipping from shaft had to get with contact to lock out power and do not run the door.